Use tube when a part needs to come forward with bite and presence, and tape when you want it warmer, rounder and a little more glued. Tube shapes the top and bottom of the wave differently, which adds even harmonics. Tape treats both halves the same and softly squashes the peaks. Try both on the same part at matched loudness and keep the one that fits.
What each one does
Saturation bends the wave as it gets louder, and the bend adds harmonics above each note. The shape of the bend decides which harmonics you get. At low drive the two can sound close. The difference grows as you push them.
When to reach for tube
Even harmonics sit an octave and two octaves above the note, so they thicken it without sounding harsh. That makes tube a good pick for a vocal, lead or snare that needs to cut through. In Torchit, set Mode to Tube and raise Drive until you hear the part step forward. Push it too far and the bite turns to fizz, so back off as soon as the part sits forward.
When to reach for tape
Tape rounds off peaks as it saturates, like gentle compression with color. It suits drum buses, bass and whole mixes, where you want things to sit together. Torchit's Tape mode gives you that rounded ceiling. Oxidex goes further as a full tape machine: Tape speed changes the character, head bump and high-end rolloff together, and its Drive saturates the lows more than the highs. Its Head Bump adds a low-shelf lift at the tape speed's head bump frequency, for extra weight.
Compare at the same loudness
Saturation makes things louder, and louder always sounds better at first. Turn on AG (Auto-Gain) so the level stays steady as you push Drive, then switch between Tube and Tape. DELTA plays only what the saturation adds, and Mix blends it back in if the full effect is too much. Judge it in the mix, not soloed. A sound that is too much on its own can be right with everything playing.
How do I compare tube and tape with Torchit?
- Insert Torchit. Put Torchit on the part you want to color.
- Turn on AG. Turn on AG so the loudness stays the same as you change Drive.
- Try Tube. Set Mode to Tube and raise Drive until you can hear the change.
- Try Tape. Switch Mode to Tape at the same Drive and listen to the difference.
- Blend it in. Keep the mode that fits, then lower Mix if the effect is too strong.
Frequently Asked Questions
Which adds more harmonics, tube or tape?
Tube adds both even and odd harmonics, because it treats the two halves of the wave differently. Tape adds mostly odd harmonics, with the lower ones strongest, for a compressed, warm sound.
Can I use tube and tape on the same track?
Yes. A common split is tube on a part that needs to come forward and tape on the bus that holds it. Keep each one light, so together they add color, not distortion.
What about Warm and Grit?
In Torchit, Warm is a smooth symmetric curve, close to tape but without the rounded ceiling. Grit is an asymmetric clip with more bite than Tube, for when you want edge.
Why does every saturation setting sound better?
Because it is louder. Match the level before you judge, with Auto-Gain or an output trim, and compare against the bypassed sound.
Plugins in this post
This tip uses Torchit 1.1.0 and Oxidex 1.1.0. Some steps may differ, or not apply, if you're on a different version. Tried this workflow, or got stuck along the way? We'd love to hear from you: contact us.